Core407I, STM32F4 Core Board

Model : DEV-00056
Supplier : Techbazar.com.bd
Techbazar.com.bd, Bangladesh

Summary STM32 small board with the STM32F407IGT6 MCU, full IO expander, JTAG/SWD debug interface.
STM32F407IGT6:the high performance STM32 MCU which features:
• Core: Cortex-M4 32-bit RISC
• Feature: a full set of single-cycle DSP instructions
• Operating Frequency: 168MHz, 210 DMIPS/1.25 DMIPS/MHz
• Operating Voltage: 1.8V-3.6V
• Package: LQFP176
• Memories: 1024kB Flash, 192+4kB SRAM
• MCU communication Interfaces:
o 3 x SPI, 4 x USART, 2 x UART, 2 x I2S, 3 x I2C
o 1 x FSMC, 1 x SDIO, 2 x CAN
o 1 x USB 2.0 high-speed/full-speed device/host/OTG controller with dedicated DMA, ULPI and on-chip full-speed PHY
o 1 x 10/100 Ethernet MAC
o 1 x 8 to 14-bit parallel camera interface
• AD & DA converters: 3 x AD (12-bit, 1μs, shares 24 channels); 2 x DA (12-bit)
• Debugging/Programming: supports JTAG/SWD (serial wire debug) interfaces, supports IAP

• AMS1117-3.3 (on bottom side), 3.3V voltage regulator
• MIC2075 (on bottom side), onboard USB power management device
• Power supply switch, powered from 5Vin or USB connection
• Boot mode switch, for configuring BOOT0 pin
• Power indicator
• VBUS LED
• Reset button
• 8M crystal oscillator (on bottom side)
• 32.768K crystal (on bottom side), for internal RTC with calibration
• JTAG/SWD interface: for debugging/programming
• USB interface
o as DEVICE, used for establishing USB communication between PC and the STM32 development board
o as HOST, connecting to USB devices such as USB flash drive through a USB OTG cable
• MCU pins expander, VCC, GND and all the I/O ports are accessible on expansion connectors for further expansion
• 5Vin pinheader, 5V power supply is required when using USB HOST/OTG
• USB HOST/OTG jumper
o short the jumper when using USB HOST/OTG
o open the jumper to disconnect from I/O port
• VBAT selection jumper
o short the jumper to use system power supply
o open the jumper to connect the VBAT to external power, such as battery
• VREF selection jumper
o short the jumper to connect VREF+ to VCC
o open the jumper to connect VREF+ to other custom pin via jumper wire
Click here to know more about this product.

Conditions

You can get the product from our office
Home delivery is also available
Delivery charge: Inside Dhaka-60 Taka, outside Dhaka-99 Taka
We will send a custom made invoice with discount amount at the time of delivery.
No existing offer will be applicable if customer avails this offer.
Once the product is purchased,it will not be refundable
Your booking does not always guarantee product delivery. Product delivery is entirely subjected to availability of stock
Color of the products may slightly vary due to photography, lighting sources or your monitor setting/ PC resolution
Product delivery may be interrupted or delayed due to natural disaster or in case of political unrest
In case of delivery outside Dhaka, customers may have to collect certain products from the nearby courier service office.

Sale