Description

This is a 3-pin motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the ‘alarm’ pin will go low.

This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3.3V. Sensor uses [email protected].

The alarm pin is an open collector meaning you will need a pull up resistor on the alarm pin. The open drain setup allows multiple motion sensors to be connected on a single input pin. If any of the motion sensors go off, the input pin will be pulled low.

The connector is slightly odd but has a 0.1″ pitch female connector making it compatible with jumper wires and 0.1″ male headers.

Specification

Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “PIR Motion Sensor (JST)”

Shipping & Delivery

Conditions

You can get the product from our office
Home delivery is also available
Delivery charge: Inside Dhaka-60 Taka, outside Dhaka-99 Taka
We will send a custom made invoice with discount amount at the time of delivery.
No existing offer will be applicable if customer avails this offer.
Once the product is purchased,it will not be refundable
Your booking does not always guarantee product delivery. Product delivery is entirely subjected to availability of stock
Color of the products may slightly vary due to photography, lighting sources or your monitor setting/ PC resolution
Product delivery may be interrupted or delayed due to natural disaster or in case of political unrest
In case of delivery outside Dhaka, customers may have to collect certain products from the nearby courier service office.