CC Debugger

The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based System-on-Chip (SoC) devices from Texas Instruments. CC Debugger also supports CCxxxx RF transceivers. In addition, CC Debugger is used for configuring the CC85xx devices with PurePath Wireless Configurator.
________________________________________
Key Features
• Performance
o Compatible with the original TI CC Debugger
o Supported Operating Systems: Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit
o Target voltage: 1.2V～3.6V
o Capable of powering the target board from the debugger
o Operating temperature: 0℃～85℃
• Supported Software
o IAR Embedded Workbench For C8051
o SmartRF Flash Programmer
o SmartRF Studio
o SmartRF Packet Sniffer
o PurePath Wireless Configurator
• Connects to PC
o Computer connection via USB interface
• Connects to target board
o Target board connection via 10-pin IDC connector (2×5 2.54mm pitch). The figure below shows the header pinout:
________________________________________
Supported Devices
• Programming and debugging the following 8051-based system-on-chips from Texas Instruments:
o CC1110, CC1111
o CC2430, CC2431
o CC2510, CC2511
o CC2530, CC2531, CC2533
o CC2540, CC2541
o CC2543, CC2544, CC2545
• Controlling the following transceivers from SmartRF Studio:
o CC1120, CC1121, CC1125, CC1175
o CC1101, CC110L, CC113L, CC115L
o CC2520
• Configuring the CC85xx devices with PurePath Wireless Configurator:
o CC8520, CC8521
o CC8530, CC8531
________________________________________
LED Status
• OFF: The debugger has no power or there is no valid firmware on the debugger.
• AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.
• RED LED BLINKING: The Debugger is in Boot Recovery Mode.
• RED LED ON: No device detected. This might be due to old firmware on the CC Debugger, or a problem with the hardware connection (make sure the target board is properly powered and connected correctly).
• GREEN LED ON: The target device has been properly detected. It is possible to start programming/debugging.
________________________________________
Package Contains
1. CC Debugger × 1
2. USB cable × 1
3. 10-pin flat cable × 1
Click here to know more about this product.